Pond bottom drains come in many sizes ranging from 40mm to 110mm,they come in different qualitys also,we at blackburn house koi stock many of them as we can.

Large Sump Bottom Drain For installation at lowest
point of pond. A must for gravity fed systems. Ideally suited for draining heaver particles to waste or filter system. Can be reduced down to 3” if required. 4” (110 mm) exhaust.

When installing plastic fittings into cement or brickwork, you can achieve a good bond between the plastic and the mortar mix by heavily covering the surfaces that will be in contact with the mortar in solvent glue. While the glue is still wet smother it in sand. The glue will partially dissolve the surface, permanently biding the sand into the surface of the plastic. Once dry (allow at least 24 hours), this will provide an idea surface for the mortar to bind to.
 

The Spindrifter
A rubber aerator on top of the drain provides a constant supply of air to the bottom of the pond for maximum oxygen enrichment. The aerators can be retro fitted to existing bottom drains.
Pumping air through the aerator dome on the bottom drain gives the maximum diffusion for oxygen absorption and creates water circulation in the pond.

When installing plastic fittings into cement or brickwork, you can achieve a good bond between the plastic and the mortar mix by heavily covering the surfaces that will be in contact with the mortar in solvent glue. While the glue is still wet smother it in sand. The glue will partially dissolve the surface, permanently biding the sand into the surface of the plastic. Once dry (allow at least 24 hours), this will provide an idea surface for the mortar to bind to.
We also keep 40mm and 50mm tomy drains.


 

Showing 4 of 4 products
Sort By

Pond Bottom Drains